Page 1 of 1
Hammond question (not on Hammond site)
Posted: Sun Sep 04, 2022 3:19 pm
by Gribnes
Is there a throat/backbore difference specifically between large shank v small shank 10M?
Thanks,
Hammond contact not functioning at the moment
Re: Hammond question (not on Hammond site)
Posted: Sun Sep 04, 2022 4:01 pm
by Kevbach33
From the Hammond site:
"M
Medium-depth cup with a V shape. This is an extremely efficient cup with the capability of duel use between section work or possibly lead on small bore, or solo work on large bore. .257 throat/T2 backbore(small bore), .265 throat /T5 backbore(large)"
This goes for all M cups. Thus, we can deduce that a 10M small shank has the .257" throat and T2 (compact) backbore, while the large has the .265" throat and T5 (most open) backbore.
Re: Hammond question (not on Hammond site)
Posted: Sun Sep 04, 2022 4:24 pm
by Gribnes
Thank you !! Of course it was in front of me...